1.) Insert shaft section of chock on top CENTERED between tires (if
necessary other section can be inserted on top). CENTER remaining
section between the tires on bottom. Insert handle into front hole
on shaft.
2.) Turn shaft CLOCKWISE until both sections are tight between tires.
There will be a spacing of approximately 2-6 inches between the sections.
3.) Insert lock pin into last hole visible BEHIND arch to hold tension.
Padlock if desired.
TO REMOVE ROTOCHOK
1.) Insert handle into the front hole on shaft. TURN SLIGHTLY CLOCKWISE
- REMOVE LOCK PIN. Remove this section by grasping shaft moving it
up and down to release contact with tires.
2.) Insert handle into front hole on the other section of chock.
Repeat up and down motion to release contact with tires. Remove chock.
REMEMBER: ROTOCHOK SHOULD BE THE FIRST THING ON WHEN PARKING
& LAST THING OFF BEFORE PULLING OUT!
